Publicidad
Idiomas disponibles
Idiomas disponibles
Figure 1
2
Bottom End of Locker
Figure 2
4
2
5
Figure 3
PAGE 3 OF 15
ASSEMBLY
VERTICAL ASSEMBLY
1. Place back (1) on a protected flat surface so that
2. Bolt side (2) to back (1) so that the side flange fits
1
3. Next, bolt top and bottom (5) to back and left side
5
4. Bolt side (2) to the back so that side flange fits
2
NOTE: Do not tighten bolts until unit is
completely assembled.
the flanges face upward. (See Figure 1)
around back – nuts to the inside. Do not use bottom
two holes; these will be used for attaching legs in
step 5. (See Figure 1)
panel. Bolt shelves (4) to left side panel. (See Figure 2)
around back. Attach side to top, bottom and
shelves. (See Figure 3)
NOTE: Do not bolt four circled holes. They will
be used when joining units together.
(See Figure 3)
0321 IH-6185
Publicidad
