Publicidad
Step
Step 7
å
Fasten the BRACKETS (57G) to the ENDS (A and B) and
LEGS (E and F). Use four BLACK 9/16" LARGE HEAD
SCREWS (1S).
å
Fasten the DRAWER MOLDING (K) to the BRACKETS on
the ENDS (A and B) and LEGS (E and F). Use four BLACK
9/16" LARGE HEAD SCREWS (1S).
å
NOTE: There are no pre-drilled holes in the MOLDING.
The SCREWS will tighten into the groove.
BLACK 9/16" LARGE HEAD SCREW
(8 used in this step)
The groove
is closer to
this edge.
www.sauder.com/service
1S
K
E
B
427360
57G
F
A
Page 13
Publicidad
