Publicidad
Idiomas disponibles
Idiomas disponibles
4.2 PHASE 1 - HMG ELECTRICAL CONNECTIONS
Rear of the
panel
1. For HMG units, an IC-2P accessory connector available as an accessory is required;
2. Before proceeding further, make sure that the SW1 dip-switches are correctly configured:
SW1 (HMG)
DIP 1
DIP 2
ON
ON
4.3 PHASE 2 - SERIAL ADDRESS SETTING OF THE HMI/BHP UNITS
To connect the units to the supervisor, it is necessary to set the correct modbus address to be assigned to the unit; please note that on VMF-E6, VMF-E5 or MULTICONTROL
supervisors, the addresses dedicated to the chillers are: 200, 201, 202, 203. For more information, refer to the documentation of the supervisor to be used.
To set a supervision address on the units, the following steps must be followed:
1. From the main screen, press the key for the HOME screen:
2020-02-20
08:52
-
22
HMG control panel (TCP)
IC-2P
(accessory)
DIP 3
DIP 4
OFF
OFF
0.0°C
+
25°C
GND
0.0°C
Vin: 230 Vac
50/60 Hz
Imax: 0.15 A
GND
Previous node
VMF network
Subsequent node
VMF network
22/03 – 6227920_01
Publicidad
