e-conolight E-WP Serie Instrucciones De Instalación

INSTALLATION INSTRUCTIONS
E-WP Series
CAUTIONS
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety
precautions should always be followed including the
READ AND FOLLOW ALL
SAFETY INSTRUCTIONS
1. DANGER- Risk of shock- Disconnect power before
installation.
DANGER – Risque de choc – Couper l'alimentation
avant l'installation.
2. This luminaire must be installed in accordance with the
NEC or your local electrical code. If you are not familiar
with these codes and requirements, consult a qualified
electrician.
Ce produit doit être installé conformément à NEC ou votre
code électrique local. Si vous n'êtes pas familier avec ces
codes et ces exigences, veuillez contacter un électricien
qualifié.
NOTE: This luminaire is rated for 120V 60Hz only.
SAVE THESE INSTRUCTIONS
FOR FUTURE REFERENCE
MOUNTING
Note: Do not recess. Also make sure fixture is weatherproof by sealing
all gaps and holes with weatherproof silicone sealant.
1. Loosen the four screws securing the lens to the housing and allow
the lens to swing down on its hinge as shown in Figure 1.
2. Remove the reflector by removing the two reflector retaining
screws and set aside.
3. Locate and remove desired conduit plug on the back or sides of
fixture housing.
4. Pull the supply leads through the conduit plug and mount the
fixture to the wall by drilling through the four drill points in the
housing in each corner at the back of the fixture and secure it to
the mounting surface.
5. All unused holes must be plugged. Apply waterproof silicone to all
mounting holes to ensure a tight seal.
following:
www.e-conolight.com
Document: CI308X43R1
Created By: TMT
6. Complete the wiring to the power source and ground (refer to
"Fixture Wiring" instructions).
7. Replace the reflector removed in Step 2 ensuring no wires are
pinched.
8. Reposition the lens and secure using the 2 screws loosened in
Step 1.
NOTE: This luminaire is rated for 120V 60Hz only.
1. Using customer supplied 90°C minimum rated wire connectors,
make the following electrical connections in the mounting box or
junction box.
a. Connect the black fixture lead to the voltage supply lead
b. Connect the white fixture lead to the neutral supply lead
c. Connect the ground lead to the supply ground lead.
FIGURE 1
| 888.243.9445 | FAX: 262.504.5409
Date:
ECO#:
FIXTURE WIRING
2015-7-31
2015-236