Pahlen LED 170VS-RGB Manual De Usuario página 8

LED unit 170VS-RGB
Electric installations
Bear in mind local electrical codes for switch box location.
The light shall always be connected via a safety transformer 12V AC of toirodal core-type (see table) to ensure correct operation
and maximum life. If more than one RGB light are installed, they shall be connected to the same transformer and via a common
power switch for synchronization, see Diagram.
The transformer's power shall be greater than the total value of all lights, please refer to the table below.
Supplied cable shall always be used for the engagement of the light.
If the light's external cable insulation or the inner conductor is damaged, it shall be replaced by a service technician or other
qualified person.
Wiring instructions Setup 1 OBS! The lights should be completely covered by the water before they come on.
For new installations
Recommendations
Each lamp is connected to the transformer by a separate cable
4m cable included in lamp package
The colour of the light
Separate cable ( not included )
WW
8
RGB - red/green/blue
The calculations of the cable lengths are made in relation to the maximum voltage drop in the electrical cables.
Circuit diagram
Example:
TR1 150W alt. 350W
Cable length and cross-section, see table
L1
IN
230V AC
N
Maximum cable lenght / Cable section
!
Always use a toroïdal transformer
1.5 mm 2.5 mm
2 2
50 m 85 m
20 m 35 m
TR1 150W alt. 350W
TR1 150W (alt. 350W)
L1
IN
IN
230V AC 230V AC
N
Wiring instructions Setup 1
For new installations
Each lamp is connected to the transformer by a separate cable
8
OUT
LA1
12V AC
75W
LA2
4.0 mm 6.0 mm 75W 10.0 mm
2 2
135 m 200 m
55 m 85 m
OUT LA1
OUT
Lamp 1
12V AC
12V AC
60W
alt.
LA2
Lamp 2
60W
LA3
Lamp 3
60W
8
ENGLISH
Cable included
4m cable included in lamp package
Separate cable not included
Separate cable ( not included )
Transformer power
2
340 m 20VA
145 m 45VA
E10084-0
2018-12-18 ASA
!
Always use a tor