Publicidad
Idiomas disponibles
Idiomas disponibles
Cod. 94716
LIST OF MAIN PART
1.handle
2.fuel tank cap
3.fuel tank
4.fuel valve
5.recoil starter
6.on/off switch
7.choke
OPERATION
Preparing the generator
Please always read the instruction manual carefully and check the generator before operating.
Fitting the handle
Firstly, place the 2 handle gaskets(supplied with the generator) over the holes on the petrol tank,
then proceed by placing the handle on top of the gaskets ensuring the 2 holes in the handles line
up with the holes on the tank.
Screw the handle onto the petrol tank using the 2 screws provided with the unit. Ensure the flat
washers are fitted under the heads of the screws.
Mixing the fuel
1. The generator uses unleaded fuel and engine grade oil.
2. You need to mix both the fuel together.
3. The proportion should be 40 parts unleaded fuel and 1 part oil (2.5% oil).
4. The mixture should be poured into an approved fuel container; this fuel container should be
clearly marked as a fuel container. Sealed and made from fuel resistant material.
5. Once the mixture has been poured, shake the fuel container well to ensure that the contents
have been thoroughly mixed.
Checking the engine fuel
Only fuel the generator in well-lit areas. Avoid fuel spillage. Never refuel the generator during
operation. Let the motor cool down for about two minutes before refueling.
8. cover
9. DC Output 12V
10. AC Output
11. AC Circuit breaker.
12. DC Circuit breaker
13. spark plug cover
14. Voltmeter
15. AC pilot lamp
17
Publicidad
