ited assessment authority, which authorises their
competence to handle refrigerants safely in ac-
cordance with an industry recognised assess-
ment specification.
•
Maintenance shall only be performed as recommended by the equipment manufacturer.
Maintenance and repair requiring the assistance of other qualified personnel shall be car-
ried out under the supervision of the person competent in the use of flammable refrigerants.
•
Repair of the appliance may only be carried out by qualified personnel who are familiar with
the risks involved and the relevant regulations. Inadequate repairs may cause serious haz-
ards. For repair service, contact the service center in your country (see
er).
•
Always disconnect the power supply when working on the appliance.
The appliance shall be stored in a room without
•
continuously operating ignition sources such as
open flames, an operating gas appliance or an
operating electric heater.
•
Do not pierce or burn the appliance.
•
Be aware that refrigerants may not contain an odor.
•
Do not use the appliance near flammable fluids or in closed rooms.
•
Ensure that no combustible objects are stored or installed near the air outlet. A distance of
at least 50 cm must be kept.
•
Keep the ventilation openings clear of obstruction.
•
Do not damage the refrigerant circuit.
Under no circumstances shall potential sources
•
of ignition be used in the searching for or detec-
tion of refrigerant leaks. A halide torch (or any
other detector using a naked flame) shall not be
used.
•
The roof air conditioner shall be installed in a vehicle with a floor area larger than 4 m².
•
Do not use means to accelerate the defrosting process or to clean, other than those recom-
mended by the manufacturer.
CAUTION! Failure to obey these cautions could result in minor or moderate injury.
•
Do not reach into air outlets or insert any foreign objects in the appliance.
•
Do not undo the upper cover of the appliance in the event of a fire. Use approved extin-
guishing agents instead. Do not use water to extinguish fires.
•
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified personnel in order to avoid a hazard.
14
dometic.com/deal