Publicidad
Idiomas disponibles
Idiomas disponibles
Switches
1. Insert the plug.
Setting of the iron temperature
Check that the indicator light of the iron is also on before ironing.
ATTENTION: After a change of setting it takes about 2 mins for the new temperature to stabilize!
Position "A":
Normal temperature
Without Softpressing soleplate:
- cotton, linen.
With Softpressing soleplate:
- wool, silk, synthetics.
If the iron spurts water, slightly increase the temperature.
Steam button
Before starting to iron or after lengthy ironing interruption, press the steam button 2 or 3 times to evacu-
ate any water which may have condensed in the steam tube.
Ironing
Vacuum / Blowing - choice of 2 speeds
A single steam control button situated on the iron allows you to both start the emission of steam and
switch from "blowing" mode to "vacuum" mode (or vice versa).
Changing from one mode to the other can be done only when the motor is off. The chosen mode stops
automatically at the end of a cycle (lasts 4 seconds). At that moment you may select the desired mode.
In addition to the vacuum and blowing functions, the steam control button enables the strength of the
flow of air from the ventilator to be regulated. When the iron is switched on, the ventilator is pre-set to
maximum capacity (100%). Changing from one mode to the other can be done only when the motor is off.
To change to reduced airflow (50%), press the steam control button twice very quickly. To go back to
maximum airflow, press the steam control button twice again.
All manuals and user guides at all-guides.com
Position "B":
Low temperature
With Softpressing soleplate:
- for extremely delicate synthetics
eg: synthetic velours, Alcantara
(synthetic suede), sport stretch
garments.
2. Turn on both switches and
wait until the green light comes
on (approx. 7 to 8 minutes).
®
4
7-8 min
Publicidad
