Problems and solutions
Before calling customer service check the following points.
Problem
• Emits a humming sound when
steam is ejected from the iron.
• Cracking sounds when the
boiler is lit.
• The green light comes on
and goes off during ironing.
• The iron is no longer pro-
ducing steam. Pressure has
fallen.
Problem
• The soleplate is dripping.
• The iron does not heat up.
• The iron is too hot.
Problem
• The vacuum produces no sound
• The tip of the table becomes
wet in the storage position.
We are glad to be of assistance. Our address is indicated on the last page.
All manuals and user guides at all-guides.com
Probable cause
• The boiler is vibrating.
• The boiler is being heated
without being refilled
• Water is warming up.
• The boiler is empty.
• The switches are off.
• The wall socket is disconnected.
Probable cause
• The iron is not ready.
• The thermostat is not well
adjusted.
• The boiler has not been
rinsed recently.
• The boiler has been rinsed
with a product other than
water.
• Disconnected at the wall.
• Switches are off.
• The thermostat is not well
adjusted.
Probable cause
• The ventilator cable is
unplugged.
• Normal condensation in the
cap.
What to do
• This noise is normal for a new
• Fill the boiler with water. See p.6.
• This is normal.
• Fill the boiler with water. See p.6.
• Switch both switches on.
• Connect to the wall socket.
What to do
• Wait for the iron ready indicator
• Adjust the thermostat following
• Rinse the boiler until the water no
• Call customer service.
• Plug in at the wall.
• Switch them on.
• Adjust the thermostat following
What to do
• Plug it in.
• Leave the unit open until the
• Use less steam. Pay attention to
10
appliance, it will disappear in the
course of use.
light to come on.
indications see p.4
longer contains any residues see p.7.
indications see p.4.
water has evaporated.
the instructions for use with
respect to vacuuming and
blowing see p.8.