Ducati Pro-I Evo Black Edition Manual Del Usuario página 33

Error
The motor is not running
The drive wheel does not turn
The motor stops while it is running
After charging it, the item does not
switch on or it switches off after
a few km.
The battery does not charge or the
item does not switch on
Pro-I Evo, Pro-I Evo AS, Pro-I Evo Max AS
Error code Indications
E.1 Engine malfunction
E.2 Control unit signal error
E.3 Accelerator lever malfunction
E.4 Control unit MOS malfunction
E.5 Phase / current error
E.6 Average current malfunction
E.7 Battery voltage error
E.8 Brake lever malfunction
12. Troubleshooting
Cause
Electrical issue, error code
present
Problems with the brakes
Motor is blocked
Motor overheating
Presence of error code
Damaged battery
Connection problems
The battery is not connected
(models with removable battery)
The battery is depleted
Damaged battery
Problems with the battery
charger
Pro-II Plus, Pro-II Evo, Pro-II Evo AS, Pro-III, Pro-III R
32
Solution
Request technical assistance
Adjust the brakes; if the problem persists,
request technical assistance
Check that the wheel is properly tightened,
check that the wheel turns without starting
the vehicle. If the problem persists, request
technical assistance
Stop the vehicle and wait for it to cool
Request technical assistance
Request technical assistance
Request technical assistance
Check that the power connector is connected.
Charge the battery to 100%
Request technical assistance
Replace the battery charger
Error Code Indications
E01 Overcurrent protection
E02 Low voltage protection
E03 High voltage protection
E04 Drive wheel guard
E05 Controller MOS Fault (up)
E06 Controller MOS Fault (down)
E07 Controller general fault
E08 Overheating protection
E09 Accelerator lever malfunction
E11 Headlight malfunction
E12 Control unit signal error
E13 On/off button malfunction