Publicidad
Idiomas disponibles
Idiomas disponibles
Attention!
This interface will work with models that are either factory amplified, or
non-amplified. Please follow the instructions carefully for your model vehicle. Failure
to do so will result in improper sound. If you are unsure if your vehicle is factory
amplified or not, please contact your local Dealership.
For models without a factory amplifier:
From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the Red wire to the accessory wire.
Note: If installing an ASWC-1 or AX-LCD (both sold separately), there will be
an accessory wire there to connect as well.
• If the aftermarket radio has an illumination wire, connect the
Orange/White wire to it.
• If the aftermarket radio has a mute wire, connect the Brown wire to it. If the
mute wire is not connected, the radio will turn off when OnStar is activated.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
The following (3) wires are only for multimedia/navigation radios that require
these wires.
• Connect the Blue/Pink wire to the VSS/speed sense wire.
• Connect the Green/Purple wire to the reverse wire.
• Connect the Light Green wire to the parking brake wire.
• Tape off and disregard the following (5) wires, they will not be used in this
application: Blue/White, Green, Green/Black, Purple & Purple/Black.
®
99-3012G
Connections to be made
From the 3012 harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the (2) 4-pin connectors together.
• Cut off and remove the resistors from the Green, Green/Black, Purple, and
Purple/Black wires.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative speaker output.
• Tape off and disregard the Pink wire with a bullet connector, it will not be used
in this application.
• The Black/Yellow wire is used for OnStar level adjustment for models that
do not come equipped with steering wheel controls. See the OnStar level
Adjustment section for further instructions.
• If retaining the factory AUX-IN jack, connect the Red & White RCA jacks to the
AUX input.
• The DIN connector is to be used along with the optional AX-LCD (sold
separately) to retain the personalization menu.
• Connect the Red wire to the accessory wire.
5
Continue to page 7
Publicidad
