Publicidad
LITE
• Check compressor terminal connections or possible cuts in cables.
• Connect cable clamps in the electronic control.
• Check that the references of each of the modules are different.
!
(If the error persists, contact the Authorised Technical Service).
• Take down the control panel's front panel and correctly connect the cable between
the control panel and the electronic control.
• This will disappear when the unit is in a position of less than 45º. Slant is detected
by the electronic control.
• Clear the wastewater channel obstruction (remove the outside cover of the unit for
access).
• Replace the EPDM seal (take down the unit and thoroughly clean the surface where
the EPDM seal is to be attached).
• Seal the cable output in the evaporator cover (remove the unit's outside cover for
access).
Solution
21
EN
Publicidad
