Removing The Blade; Installing The Blade - Makita XSL03 Manual De Instrucciones

1
3
► 1. Unlocked position 2. Locked position 3. Stopper
pin

Removing the blade

Loosen the hex bolt holding the center cover using the
hex wrench. Raise the blade guard and center cover.
1
2
► 1. Center cover 2. Hex wrench 3. Blade guard
Press the shaft lock to lock the spindle and use the hex
2
wrench to loosen the hex socket bolt. Then remove the
hex socket bolt, outer flange and blade.
► 1. Shaft lock 2. Hex wrench 3. Hex socket bolt (left-

Installing the blade

Mount the blade carefully onto the spindle, making
sure that the direction of the arrow on the surface of the
blade matches the direction of the arrow on the blade
case.
3
► 1. Arrow on the blade case 2. Arrow on the blade
Install the outer flange and hex socket bolt. Tighten the
hex socket bolt counterclockwise using the hex wrench
while pressing the shaft lock.
19 ENGLISH
2
4
5
handed) 4. Loosen 5. Tighten
1
3
1
2