THC
• Check if the lid is properly closed.
• Check the temperature regulation.
• Check that the probe is correctly connected.
• Check if the condenser is unobstructed.
The equipment is very noisy
• Check if the equipment is sitting on a levelled surface.
• Check if the vents are unobstructed.
• Check if the screws and nuts are perfectly fastened.
• Check if the compressor has any problems/does not work properly.
The equipment has too much ice on the walls
• Check if the lid seals are correct.
• Check if the local temperature and relative humidity conditions exceed the
equipment's climate classification (found on the rating plate).
If none of the above scenarios apply, we advise that you contact an authorized dealer.
WARNING
• Never attempt to repair the equipment or its electrical components by your own
endeavour. Any repairs made by an unauthorized individual are dangerous to the
user and may result in the warranty's nullification.
• In case of gas leaks or fire, do not use water to extinguish the flames, only dry-
agent extinguishers.
•
11. Prolonged Non Operation
If you intend to disconnect the equipment for a long period of time, you must proceed
as follows:
• Remove the products from inside the equipment.
• Disconnect the equipment by removing the power cord from the outlet.
• Open the lids and let it adapt to room temperature.
• Clean the equipment.
• Leave the lids slightly open to prevent odours.
12. Controllers
Carel PJEZS1E0G0 Controller
Fig. 8 - CAREL PJEZS1E0G0 Controller
27
English