OHAUS Adventurer AX124 Manual Del Usuario página 5

Do not position the equipment such that it is difficult to reach the power
connection.
Make sure that the power cord does not pose a potential obstacle or
tripping hazard.
Operate the equipment only under ambient conditions specified in these
instructions.
This equipment is for indoor use only.
Do not operate the equipment in wet, hazardous or unstable environments.
Do not allow liguids to enter the equipment.
Do not load the equipment above it's rated capacity.
Do not drop loads on the platform.
Do not place the equipment upside down on the platform.
Use only approved accessories and peripherals.
Disconnect the equipment from the power supply when cleaning.
Service should only be performed by authorized personnel.
WARNING: Electrical shock hazards exist within the housing. The housing
should only be opened by authorized and qualified personnel. Remove all
power connections to the unit before opening.
WARNING: Never work in an environment subject to explosion hazards! The
housing of the instrument is not gas tight. (Explosion hazard due to spark
formation, corrosion caused by the ingress of gases).
Intended Use
This instrument is intended for use in laboratories, pharmacies, schools, businesses
and light industry. It must only be used for measuring the parameters described in
these operating instructions. Any other type of use and operation beyond the limits
of technical specifications, without written consent from OHAUS, is considered as
not intended.
This instrument complies with current industry standards and the recognized safety
regulations; however, it can constitute a hazard in use.
If the instrument is not used according to these operating instructions, the intended
protection provided by the instrument may be impaired.
EN-3