TM Electron TMHC109 Manual De Instrucciones página 16

5. Push the cutting unit back into place on the Trimmer until you
hear a click (fig. 14).
Replacing The cutting Unit
If your cutters become damaged or worn, do not continue using the
Trimmer. Replace cutters immediately.
1. Open the cutting unit.
2. Remove the old cutting unit by pushing against the teeth of the
cutting unit (fig. 11).
3. Insert the notch of the new cutting unit into the guiding slot
(fig. 13).
4. Push the cutting unit back onto the Trimmer until you hear a
'click' (fig. 14).
WARNING
1. Never immerse the machine in water or rinse under the tap.
(Fig.15)
2. Only the trimmer attachment can immerse in water or rinse
under the tap separate from machine (Fig.16)
16
CASTELLANO
ENGLISH