Publicidad
Idiomas disponibles
Idiomas disponibles
Quick Start
To attach the MultiSync LCD monitor to your system, follow these instructions:
1. Turn off the power to your computer.
2. For the PC or Mac with DVI digital output: Connect the DVI-D to DVI-D signal cable to the
connector of the display card in your system (Figure A.1). Tighten all screws.
For the PC with Analog output: Connect the 15-pin mini D-SUB to DVI-A signal cable to the
connector of the display card in your system (Figure A.2).
For the Mac: Connect the MultiSync Macintosh cable adapter to the computer (Figure B.1).
Attach the 15-pin mini D-SUB signal cable to the MultiSync Macintosh cable adapter
(Figure B.1).
NOTE: Some Macintosh systems do not require a Macintosh cable adapter.
3. Remove connector cover. Connect the DVI signal cable to the connector on the back of the
monitor. Place the video signal cable (Figure C.1).
Replace connector cover.
NOTE: Incorrect cable connections may result in irregular operation, damage display quality/
components of LCD module and/or shorten the module's life.
4. Remove power cord cover. Connect one end of the power cord to the AC inlet on the back of
the monitor and the other end to the power outlet (Figure D.1). Replace the power cord
cover.
NOTE: Please refer to Caution section of this manual for proper selection of AC power cord
5. Press an arrow point " " portion with take off connector cover.
6. Check the Vacation Switch on the right hand side of the monitor is in the ON position. Turn on
the monitor with the Power Button (Figure E.1) and the computer.
NOTE: There are two switches: one on the right side and one on the front side of the monitor.
DO NOT switch on/off quickly.
7. To complete the setup of your MultiSync LCD monitor, use the following OSM controls:
• Auto Adjust Contrast (Analog input only)
• Auto Adjust (Analog input only)
Refer to the Controls section of this User's Manual for a full description of these OSM controls.
NOTE: If you have any problems, please refer to the Troubleshooting section of this User's
Manual.
01b_English
Figure A.1
10
Figure A.2
English-4
2/26/02, 10:06 AM
Publicidad
