cam AREA ZERO+ Manual De Instrucciones página 25

AREA ZERO+ CSI - R129 omologato lingue ok_Layout 1 11/03/19 16:29 Pagina 25
the metal button on the low part of the
car seat (1) and pull the harness towards
you (2).
4b. ADJUSTING THE HEIGHT OF THE
HARNESS: push the handles on the rear
part of the backrest (1) let the harness go
through the slots on the backrest till you
reach the required position (2). The 2
harnesses must be on the same level, they
must be well tightened and not twisted.
The harness must be adjusted on the basis
of the size of your child, so they must be at
the height of your child's shoulders or
slightly higher.
4c. USING THE SAFETY HARNESS: to
open the buckle, push the red button
(1). To fasten it, take the 2 side
harnesses, place the metal left hook
on the right one (3) and insert them
simultaneously inside the buckle (4)
until you hear a click (5). To adjust the
harnesses, pull towards you the
central harness (6).
5. INSTRUCTIONS FOR IN-CAR USE:
5a. VEHICLE SEATS: the safety car seat
can be fitted either on the front
passenger seat or on the rear seats of
the car, and it must always be fitted on
the vehicle in the rear facing position
movement of the vehicle). If fitted on the
front passenger seat, you must disable
airbag; if this is not possible. (pLEASE
NOTE that not in all vehicles is possible
to disable airbag, in case of any doubt
please contact the car manufacturer), it
is obligatory to fit the car seat on the
rear passenger seats.
5b. HARNESSES: following regulation
UN/ECE nr 16 or equivalent standard,
it is compulsory to fit the safety car
seat using the vehicle belts. It must be
used with 3 point belts only.
6. FITTING THE CAR SEAT WITHOUT BASE:
6a. Place the car seat with the child
looking at the back of the vehicle seat.
The car seat must be horizontal on the
vehicle seat and leaning against the
vehicle seat. The car seat handle must
be in the position for transport by hand
(fig. 1, detail B).
6b. Fasten the 3 point vehicle belt.
6c. Take the abdominal belt "A" and place
it in the 2 side guides of the car seat.
6d. Take the belt "T", wrap it around
the back of the car seat (1). Thread
this part of the belt through the
rotating belt guide in the back of the
car seat (2), (3).
6e. Rotate the carrying handle into the
in-car obligatory position (fig. 1, part.
A).
6f. To fit in the correct way your car
seat, grip the car seat and keep it
held in place, and then with the
other hand pull firmly the "T" belt
until the slack has been removed
and the belt is well tightened.
ATTENTION: Always check the car seat
is correctly fitted by attempting to move
it. Make sure the car seat and the
carrying handle are leaning against the
vehicle seat unit. On the contrary, the
vehicle seat unit might be incorrectly
adjusted or the car seat might be
incorrectly positioned. To remove the
car seat adjust the handle in the carrying
position, unfasten the belt and remove
it from the car seat rotating belt guide
and from the side guides.
FITTING THE CAR SEAT WITH THE 2
IN 1 BASE (ART. S132)
This is an "i-Size" child restraint system.
It is approved according to Regulation
Number 129 for use on seats of "i-Size"
compatible cars as stated in the car
manufacturer's instruction book. In case
of doubt, contact the manufacturer or
dealer of this car seat.
The car seat is suitable for use by
children in the following categories:
23