Makita HR3011FC Manual De Instrucciones página 9

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Capacities
No load speed
Blows per minute
Overall length
Net weight
Safety class
Optional accessory
Model:
Applicable workpiece and workmode
Suction performance
Operating stroke
Suitable drill bit
Net weight
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s). The lightest and heaviest combinations, according to
EPTA-Procedure 01/2014, are shown in the table.
Intended use
The tool is intended for hammer drilling and drilling in
brick, concrete and stone as well as for chiselling work.
It is also suitable for drilling without impact in wood,
metal, ceramic and plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted noise level determined accord-
ing to EN62841-2-6:
Model HR3011FC
Sound pressure level (L
Sound power level (L ) : 101 dB (A)
WA
Uncertainty (K) : 3 dB (A)
Model HR3012FC
Sound pressure level (L
Sound power level (L ) : 102 dB (A)
WA
Uncertainty (K) : 3 dB(A)
Concrete
Core bit
Diamond core bit (dry type)
Steel
Wood
) : 90 dB (A)
pA
) : 91 dB(A)
pA
HR3011FC
369 mm
4.4 - 4.8 kg
DX10 (For HR3011FC)
for concrete drilling only
(not for metal or wood, and not for core drilling or chiseling)
Model HR3001C
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Model HR3011FC with DX10
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Model HR3012FC with DX11
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
NOTE: The declared noise emission value(s) has
been measured in accordance with a standard test
method and may be used for comparing one tool with
another.
NOTE: The declared noise emission value(s)
may also be used in a preliminary assessment of
exposure.
9 ENGLISH
HR3012FC HR3001C
30 mm
80 mm
80 mm
13 mm
32 mm
-1
0 - 840 min
-1
0 - 4,500 min
386 mm 369 mm
4.5 - 4.7 kg 4.1 - 4.5 kg
/II
DX11 (For HR3012FC)
350 l/min
Up to 190 mm
Up to 265 mm
1.2 kg
) : 92 dB(A)
pA
) : 103 dB (A)
WA
) : 93 dB(A)
pA
) : 104 dB (A)
WA
) : 93 dB(A)
pA
) : 104 dB (A)
WA