System Requirements - EHEIM LEDcontrol+ 4200140 Instrucciones De Uso

4.1 System requirements

WLAN-compatible (smart phone, tablet, notebook etc.)
5. Start-up
5.1 Setting up or connecting to a network
Connect the plug connectors of the EHEIM power supply b and the powerLED+ lamp
c with the LEDcontrol+ a.
When using an EHEIM 2-way switch d Article-number 4200050, multiple powerLED+
can be operated.
Not included in the scope of delivery! The maximum load of the power supply must
be observed (see type plate of the EHEIM power supply of the lamp)
Insert the plug of the EHEIM power supply in the power socket.
The statusLED (5) of the LEDcontrol+ glows:
• White blinking LED: A network is being searched or set up.
• Blue LED master mode: the controller has set up a new network.
• Green LED slave mode: The controller is connected to the master con-
troller.
5.2 Connection to the #EHEIM LEDcontrol+ WLAN network
Open the network settings of the end device such as notebook, tablet or smart phone
and connect to the #EHEIM LEDcontrol+ WLAN network.
5.3 Go to the website
• Open the browser and the web address
http://eheimledcontrolplus.local or http://192.168.1.1.