LUTEC 7150630272 Manual Del Propietário página 5

4. Guide the electrical wire on the fixture (F) through the bottom
hole of the top pole (A). Insert the threaded ends of the
fixture (F) into the holes on the top
preassembled ground wire on the bar of the finial (E) to the
threaded end of the fixture (F) before securing the assembly
from the inside with previously removed washers and nuts.
Tighten with a 1/2 in. ring spanner (not included).
Repeat for remaining fixtures (F).
5. Connect white wire from each fixture (F) to the white wire
(GG) by twisting a wire nut (EE) onto bare ends of the wires.
Connect the black wire from each fixture (F) to the black wire
(HH) by twisting a second wire nut (EE) onto the bare ends
of the wires. Secure the wire nuts (EE) with electrical tape
(not included).
Hardware Used
Wire Nut
EE
GG
White wire
HH
Black wire
6. Replace the finial (E) on the top pole (A) with the previously
removed screws.
7. Secure the top pole (A) to the middle pole (B), securing
with the preassembled set screws. Tighten with
screwdriver (not included).
pole (A), installing the
x 2
x 1
x 1
flathead
5
4
5
E
EE
A
6
7
E
A