Husky HOTC5623BB2S Guía De Uso Y Cuidado página 8

Operation
1
Locking and unlocking the unit
IMPORTANT : The drawers must be fully closed before
locking / unlocking the unit.
□ Insert the key (K) and turn it fully to the left to lock.
□ Remove the key (K).
□ Insert the key (K) and turn it fully to the right to unlock.
□ Remove the key (K).
K
3
Installing the drawers
□ Pull the slides and slide carrier out until fully extended.
□ Hold the slide on the cabinet while aligning it with
the slide on the drawer.
□
Slightly insert one side and repeat for the other side.
□ Slowly push the drawer until it is fully closed to
engage the slide.
□ Open the drawer and close it to verify proper
operation.
2
Removing the drawers
□ Fully extend and empty the drawer.
□ Depending on the slide, either lift or lower the
release lever on both sides so the slides can ride over
the stops. Pull out to remove.
4
Installing the LED work light
□ Connect the USB wire with the adapter.
□ Plug in the magnetic LED work light (O) on tool chest for
extra light.
□ Press the button on the LED light to turn the light on for use.
8
O