Senix CHX2 Manual Del Operador página 9

When battery pack is not in use, keep it
away from other metal objects like paper
clips, coins, keys, nails, screws, or other
small metal objects that can make a
connection from one terminal to another.
STORAGE
Keep the charger clean and clear of debris.
Do not allow foreign material to get into the
recessed cavity or onto the contacts. Wipe
the charger clean with a dry cloth. Do not
use solvents or water, and do not place the
charger in wet conditions.
• Unplug the charger when there is no
battery in it.
• Charge the battery before placing it in
storage.
• Store the charger at normal room
temperature. Do not store it in excessive
heat.Do not use the charger in direct
sunlight or in damp conditions. Do not
charge outside. Recharge at room
temperature. If the battery is hot, allow
it to cool down before recharging.
Disconnect the power supply before
maintenance or cleaning.
• To maximize the life of the battery, Fully
charge before storage.
• After charging, the battery pack may
be stored in the charger, as long as the
charger is not plugged in.
• Do not store the battery pack on the tool.
• Store the battery in a clean, dry place.
Cover it in order to provide added
protection.
ENVIRONMENTAL PROTECTION
Waste electrical products must not
be disposed of with household waste.
EN - 8
According to the European Battery
Directive, defective or used battery packs/
batteries, must be collected separately and
disposed of in an environmentally correct
manner. Please recycle where facilities
exist. Check with your local authorities or
retailer for recycling advice. It will then be
recycled or dismantled in order to reduce
the impact on the environment and for
human health since they contain hazardous
substances.
TROUBLESHOOTING
Suspected malfunctions are often due to
causes that the users can fix themselves.
Therefore, check the product using this
section. In most cases the problem can be
solved quickly.
POSSIBLE
PROBLEM
CAUSE
The The charger
charger is charging
doesn't abnormally
work
The charger
broken
Red light Temperature
and green out of
light flash working
alternately range of the
at a battery pack
frequency
of 1 Hz
during
operation
If further assistance is required, take the
unit to a qualified service dealer.
SOLUTION
Contact an
authorized
service
center.
Contact an
authorized
service
center.
Remove the
battery pack
from the
charger,wait
for 15
minutes to
cool down.
WWW.SENIXTOOLS.COM