Descargar Imprimir esta página

Truper PULA-7A3 Manual página 3

Ocultar thumbs Ver también para PULA-7A3:

Publicidad

Technical Data
Code
Description
Discs
Voltage
Frequency
Current
Power
Speed
Duty cycle
Conductors
Insulating
WARNING
Avoid the risk of electric shock or severe injury. When the power cable gets damaged
it should only be replaced by the manufacturer or at a
The build quality of the electric insulation is altered if spills or liquid gets into the tool while in use.
Do not expose to rain, liquids and/or dampness.
Before gaining access to the terminals all power sources should be disconnected.
WARNING
Power Requirements
WARNING
Tools with double insulation and reinforced insulation eliminate the
need of a grounded power cord with three prongs or a grounded power connection.
WARNING
When using an extension cable, verify the gauge is enough for the
power that your product needs. A lower gauge cable will cause voltage drop in the line,
resulting in power loss and overheating. The following table shows the right size
to use depending on cable's length and the ampere capability shown in the
tool's nameplate. When in doubt use the next higher gauge.
Ampere
Capacity
from 0 A and up to 10 A
from 10 A and up to 13 A
from 13 A and up to 15 A
from 15 A and up to 20 A
WARNING
When operating power tools outdoors, use a
extension cable labeled "For Outdoors Use". These extensions are specially designed for
operating outdoors and reduce the risk of electric shock.
16 AWG x 2C with insulating temperature of 221 °F
Class II
Number of
Conductors
3 (one grounded)
* It is safe to use only if the extensions have a built-in artifact for over current protection.
AWG = American Wire Gauge. Reference: NMX-J-195-ANCE
PULA-7A3
16626
Polisher
7"
127 V
60 Hz
10 A
1.6 Hp
600 - 3 300 RPM
30 minutes work per 15 minutes idle.
Maximum 3 hours per day.
Grade IP
Power Cord Grips used in this product: Type Y.
Tool Build Quality: Reinforced insulation.
Thermal insulation on motor winding: Class B.
Authorized Service Center.
Extension gauge
from 5.9' to 49.2'
18 AWG( * )
16 AWG
14 AWG
8 AWG
grounded
IP20
|
higher than 49.2'
16 AWG
14 AWG
12 AWG
6 AWG
ENGLISH
3

Publicidad

loading

Este manual también es adecuado para:

16626Pro pula-7a3