Publicidad
Safety warnings for polishers
This power tool is intended to function as a polisher, read all safety warnings, instructions,
illustrations and specifications provided with this power tool.
• Failure to follow the instructions outlined below may
result in electric shock, fire and/or serious injury.
• Never have the car running when using the polisher in an
enclosed place.
• It is not recommended for use in operations such as
grinding, planing, sanding or cutting.
• Operations for which this tool was not designed may
cause an accident and result in personal injury.
• Do not use accessories that are not specifically designed
and recommended by the manufacturer.
• Before starting the polishing job, make a test. In the
event the tool makes strange sounds or vibrates in an
unusual way, please turn it off. Disconnect it and take it to
a
Authorized Service Center.
• When not in service the tool shall be turned off and
disconnected.
• Prevent unexpected starting. Keep your fingers away
from the On /Off switch when connecting the tool into the
power outlet.
• To prevent electric shock, keep the tool dry and clean,
free of any oil or grease residue.
CAUTION
• Keep the power cable away from the
tool trajectory while polishing. Otherwise the disc can trap
and cut the cable exposing the user to electric shock.
• Do not force the tool. Hold it firmly by both handles. Do
not use force downwards, otherwise the tool movement
will slow down, reducing quality in the job and severely
damaging the tool.
• Take good care of the tool. The job is easier if it is in
good conditions.
WARNING
• Wear safety glasses.
• Keep persons present at a safe distance from the work
area. Anyone entering the work area must wear personal
protective equipment.
• Fragments of the workpiece or a broken attachment can
break off and cause damage beyond the immediate area
of operation.
• Put the power cord away from the rotating accessory.
• If control of the power tool is lost, the cord may be cut or
entangled and the operator's arm or hand may be pulled
into the rotating accessory;
• Never release the power tool until the accessory comes
to a complete stop.
• The rotating accessory may snag on a surface and pull
the power tool out of your control;
• Do not operate the power tool while carrying it at your
side.
• Accidental contact with the rotating accessory can catch
on clothing, pulling the accessory toward your body;
• Regularly clean the vents on the power tool.
• The motor fan directs dust into the housing and excessive
accumulation of metal dust can cause an electrical hazard;
• Do not use the power tool near flammable materials.
• Sparks can ignite these materials
• Do not use accessories that require liquid refrigerants.
• The use of water or other liquid coolants can result in
electric shock or electrocution.
• The rated speed of the accessory must be at least equal
to the maximum speed marked on the power tool.
• Accessories running faster than their rated speed may
break and become detached.
• The outside diameter and thickness of the accessories
must be within the rated capacity of the power tool.
• Incorrectly sized fittings cannot be properly protected or
controlled.
ENGLISH
5
Publicidad
