ingenuity Swing 'n Go Portable Swing Hugs & Hoots 10247 Manual Del Usuario página 3

IMPORTANT
• The provided USB cord is 183cm in length.
• This product contains magnets.
• Please read all instructions before assembly and use of the product.
• Care should be taken in unpacking and assembly.
• Examine product frequently for damaged, missing, or loose parts.
• DO NOT use if any parts are missing, damaged, or broken.
• Contact Kids2 for replacement parts and instructions if needed. Never substitute parts.
• This product does not replace a cot or a crib. Should the child fall asleep, then it
should be placed in a suitable cot or crib.
Care and Cleaning
• Seat pad and headrest – Remove from frame. Fasten buckles on seat restraint
and seat pad. Fasten all hook-and-loop patches to the corresponding patch.
Machine wash with cold water, gentle cycle. No bleach. Tumble dry, using low heat.
• Toy bar and toys – Wipe clean with a damp cloth and mild soap. Air dry.
Do not immerse in water.
• Frame – Wipe the metal frame with a soft, clean cloth and mild soap.
• Storage – When putting swing away for storage, always store in a dry location,
away from any heat sources, and out of the sun.
FCC Statement / CAN ICES-3 (B) / NMB-3(B)
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
1 this device may not cause harmful interference, and
2 this device must accept any interference received, including interference that may cause undesired
operation.
WARNING: Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
– 3 –