Publicidad
Idiomas disponibles
Idiomas disponibles
EN
1
DESCRIPTION
1.1
PURPOSE
This machine is used for domestic lawn mowing. The cutting
blade must be approximately parallel to the ground. All four
wheels must touch the ground while you mow.
1.2
OVERVIEW
Figure 1-12
Handle switch
1
Start button
2
Upper handle
3
Lower handle
4
Rear discharge flap
5
Height adjustment lever
6
Battery compartment flap
7
Grass catcher
8
Mulch plug
9
Knob (lower handle)
10
Self-propelled speed control
11
Self-propelled drive lever
12
Knob
13
Bolt
14
Slot
15
Grass catcher hook
16
Safety key
17
Battery release button
18
Blade
19
Spacer
20
Mounting nut
21
Storage switch
22
2
GENERAL SAFETY
WARNINGS
Read all safety warnings, instructions, illustrations and
specifications provided with this machine. Failure to
follow all instructions listed below may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
The term "power tool" in the warnings refers to your mains-
operated (corded) power tool or battery-operated (cordless)
power tool.
English (Original Instructions)
WARNING
3
INSTALLATION
WARNING
Do not use accessories that are not recommended by the
manufacturer.
WARNING
Do not put in the safety key or the battery pack until you
finalised the assembly of all the parts.
3.1
UNPACK THE MACHINE
WARNING
Make sure that you correctly assemble the machine before
use.
WARNING
•
If parts of the machine are damaged, do not use the
machine.
•
If you do not have all the parts, do not operate the
machine.
•
If parts are damaged or missing, contact the service
center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance with
local regulations.
WARNING
For your personal safety, do not insert battery before the
tool is assembled completely.
3.2
UNFOLD THE LOWER HANDLE
Figure 2
1. Pull and turn the handle knobs 90°.
2. Unfold the lower handle.
3. Line up the handle knobs in one of the three positions on
the brackets.
4. Turn the handle knobs 90° until they engage the holes in
the brackets.
Make sure that the two handle knobs are in the same
position.
WARNING
Do not make damage to the cables when you fold or unfold
the handle.
4
NOTE
Publicidad
