Russell Hobbs Glass Touch 14742-56 Instrucciones página 130

milk
5 If you like milk in your coffee, use warm or hot milk, to avoid overcooling the coffee. To
extract maximum flavour from the coffee, it should be cool enough not to scald or burn the
mouth, but hot enough to let the flavour fill the mouth, nose and sinuses, not just the taste
buds.
bottled water
6 If you use bottled water, check that there are no added ingredients, flavourings, etc., and use
"still" water, not "sparkling". The carbon dioxide which gives the "sparkle" will adversely affect
the flavour of your coffee.
taste
7 Don't be tempted to reheat coffee in the appliance. You'll damage the appliance and the
coffee will be undrinkable.
8 Clean the filter holder, filter, and carafe after each use. Residue from a previous brew will spoil
your coffee.
preparation
9 Sit the appliance on a stable, level, heat-resistant surface.
10 Route the cable so it doesn't overhang, and can't be tripped over or caught.
11 Don't plug it in yet.
filling
12 If it's just been used, let the coffee maker cool down for at least 10 minutes.
13 If it's in keep warm mode, and ] is flashing on the display, press and release ] to turn it off.
14 Use the carafe to fill the reservoir, to avoid overfilling.
15 Remove the carafe from the hotplate.
16 Press the lever at the rear of the carafe lid, above the handle, to open the carafe lid.
17 Lift the lid off the reservoir.
18 Fill the reservoir with at least 2 cups of water, but not above the max mark.
19 Replace the carafe on the hotplate.
20 You'll feel some resistance as the non-drip valve is pushed up by the carafe lid.
21 Alternatively, you may lift the reservoir off the appliance, fill it in the kitchen, and carry it back
to the appliance.
22 If you do this, make sure that the reservoir is in place, and the catches on the reservoir are
hooked over the tabs in the body of the appliance, before you proceed.
23 Replace the reservoir lid.
24 Use the grip at the bottom of the filter housing to swing it out from the coffee maker.
25 Put filter-ground coffee into the filter. The amount will vary with the type of coffee and
individual taste, but we suggest two rounded teaspoons per cup of water.
26 Swing the filter housing back into place. You should hear it click as the catch locks into place.
brew strength
27 If you want a lighter brew, turn the brew strength control (on top of the lid) clockwise to
lighten the brew.
28 It works by diverting some of the water past the coffee grounds.
switch on
29 Put the plug into the power socket.
30 The display will light up and 12:00 will flash.
coffee now
31 Ignore the clock.
32 Press and release the ] button.
33 The button will flash twice.
130