Russell Hobbs Glass Touch 14742-56 Instrucciones página 131

34 ] will show on the display.
35 Shortly afterwards, coffee will start to drip into the carafe.
36 When it's done, the hotplate will keep the carafe warm.
coffee later
37 Set the clock to the correct time.
a) Press and release the h button until the correct hour is shown
b) It's a 24 hour clock.
c) Press and release the min button until the correct minute is shown
d) Leave the buttons alone for 5 seconds, to set the time.
38 Set the timer to the time you want to start brewing.
a) Press the T button, and keep it pressed till the display flashes (2 seconds).
b) Press and release the h button until the correct hour is shown
c) Press and release the min button until the correct minute is shown
d) Press and release the T button.
e) auto will show on the display, flashing.
f) Press and release the ] button.
g) auto will show on the display.
, If you overshoot, you can't step back. Either go right round (24 hours or 60 minutes), or
unplug the coffee maker, to reset the display to 12:00.
39 The clock will retain its settings until the coffee maker is unplugged. It will reset to 12:00 next
time you plug it in.
leave it alone
40 That's it – leave it alone till the preset time comes round, and it makes your coffee – don't
fiddle with it, you might upset it.
41 At the time you set, the coffee maker will start up.
remember
42 If you forget what time you've set it to, pressing the T button will change the display to
show you the time you've set it to.
43 After 3 seconds, it'll revert to the correct time.
a quick cup
44 If you want a quick cup of coffee before the brewing cycle has finished:
45 You can remove the carafe at any time. The non-drip valve will prevent coffee dripping on to
the hotplate..
46 To prevent the filter holder overflowing, replace the carafe on the hotplate within about 20
seconds. This may not sound much, but you'll find it's more than enough time to pour a
couple of cups of coffee.
47 When you replace the carafe on the hotplate, the non-drip valve opens, to let any remaining
coffee through.
hotplate
48 The hotplate will keep the coffee hot for two hours.
49 During this time, the ] on the display will flash.
50 After two hours, it'll turn all heating off.
51 If left for much more than an hour, chemical changes in the coffee liquor start to affect the
flavour. It's best to pour it away and make a fresh pot.
52 When the carafe is empty, switch the coffee maker off and unplug it from the power socket.
53 Let the appliance cool for about 10 minutes before adding water or re–using, to avoid
spitting.
131