Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
SM 2610028628 01-13 E_SM 2610028628 01-13 E.qxp 1/11/13 2:46 PM Page 13
Attaching the Smart Guard
To prevent personal injury, always disconnect
WARNING
plug from power source before attaching or
removing the Smart Guard System.
POSITIONING THE RIVING KNIFE
1.
Remove table insert using finger hole.
2.
Raise the blade as high as it will go and set it perpendicular
to table (0° on bevel scale) (Fig. 8).
Rotate the riving knife release lever 1 clockwise, so that it
3.
points upward (Fig. 8).
Pull riving knife 2 towards release lever to disengage it from
4.
the pins 3.
Slide the riving knife 2 up to its highest position, so that it is
5.
directly over the center of the blade (Fig. 9).
Align holes in riving knife with pins 3 and lock the release
6.
lever 1 by rotating it counterclockwise. Push/pull riving knife
to verify that it is locked in place (Fig. 9).
7.
Replace table insert (Fig. 10).
System
FIG. 8
FIG. 9
13.
2
1
2
3
1
Publicidad
Tabla de contenido
