Publicidad
Idiomas disponibles
Idiomas disponibles
PW-100 v5
PW-100 v5
COMPONENTS AND RECOMMENDED LOCATIONS IN THE VEHICLE
(1) Electronic unit
(1) Digital keyboard & internal microphone
(1) 100W loudspeaker
(2) External microphones
(1) Internal speaker
(1) Keyboard harness
(1) Power cable (battery)
(1) Fuse 15A
(1) Speaker extension cables
(1) Loudspeaker and auxiliary load harness
INSTALLATION AND ELECTRIC DIAGRAM
To install the equipment, see the installation diagram shown on page 4.
Avoid leaving visible cables in the cabin to maintain the vehicle's aesthetics unaffected.
If there are any cables left disconnected, insulate them with tape; disconnected cables
making an undesired contact can cause a malfunction.
Electronic Unit
Place it on a hidden location for aesthetic purposes. Make sure that the
location allows some ventilation into the unit to avoid overheating.
Digital Keyboard
To facilitate the handling of the equipment, place the keyboard on a
location within the driver's reach, such as the console of the vehicle. Clean
the surface where the keyboard is to be sticked to ensure an adequate
adherence. Remove the protective liner from the adhesive pad in the back
side and stick it to the surface.
To clean the keyboard, gently wipe it with a dry cloth. Do not use water or
any solvent.
Loudspeaker
When selecting the location for the loudspeaker, keep in mind that while
this component is water resistant, it is not immersion-proof.
The loudspeaker must be placed as far as possible from the keyboard
(where the internal microphone is located) in order to avoid feedback.
External Microphones
The microphones require an assembly procedure, shown on the next page.
There are 3 recommended locations to place them, see the installation
instructions on the next page.
Internal Speaker
Place the speaker out of view, without affecting the sound.
EXTERNAL MICROPHONES INSTALLATION INSTRUCTIONS
Shell
Microphone
Mounting
tape
All manuals and user guides at all-guides.com
EXTERNAL MIC
DIGITAL KEYBOARD
& INTERNAL MIC
ELECTRONIC UNIT
PW-100
100W
LOUDSPEAKER
INTERNAL SPEAKER
EXTERNAL MIC
Each microphone includes a shell to hold
it in place and protect it from the elements.
Depending on the installation procedure, it can
be more convenient to assemble microphone
and shell either before or after the wiring.
For instance, if the wiring requires to pull
the cable through a narrow space, it is
recommended to assemble after wiring.
2
2
PW-100 v5
PW-100 v5
Microphone + shell assembly procedure
1. Insert the cable in the shell by pressing it with your fi nger.
3. Remove the liner from the tape and stick it to the shell.
Location A
Inside the rearview mirror.
This location offers the highest
sound volume, yet the most
time consuming installation, as
it requires to take parts of the
vehicle apart.
Location B
In the gap of the front doors.
Select a surface to place the
microphone, so that it faces to
the exterior from inside the gap.
Once the surface is selected,
the installation is fairly easy.
Location C
Between the windshield and
the hood (at the right-most and
left-most locations).
This location offers the fastest
installation, yet the lowest
sound reception.
2. Push the microphone into the shell (do not pull the cable!).
4. Stick the shell on the selected surface, previously cleaned
with a 1:1 solution of isopropyl alcohol in water.
Recommended spots to install the microphones
There are three recommended spots in the vehicle (see
fi gure to the left), they differ with regard to ease of
installation, volume of the sound reception and visibility
(see table below).
You can select a location according to your preferences.
A
B
Rapid installation
Sound volume
Hidden
YES
YES
3
3
C
NO
Publicidad
