Hilti NURON SB 6-22 Manual De Instrucciones Original página 27

3 Description
3.1 Product overview
3.2 Intended use
The product described is a cordless bandsaw. It is designed for cutting metals and plastics.
The product is designed for operation with both hands.
For this product, use only Hilti Nuron lithium-ion batteries of the B 22 series. For optimum performance,
•
Hilti recommends the batteries stated in the table at the end of these operating instructions for this
product.
• For these batteries, use only Hilti chargers of the type series stated in the table at the end of these
operating instructions.
3.3 Items supplied
Bandsaw, operating instructions
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
3.4 Status indicators of the Li­ion battery
Hilti Nuron Li-ion batteries can indicate state of charge, fault messages and the battery's state of health.
3.4.1 Indicators for state of charge and fault messages
WARNING
Risk of injury by a falling battery!
▶ If the release button is pressed with a battery inserted in the product, subsequently check that the battery
is correctly re-engaged and secure.
Short-press the release button of the battery to get whichever of the following status indications is applicable
at the time.
State of charge and, if applicable, faults are indicated constantly as long as the connected product is
switched on.
*2354065*
1
2354065
Grip with safety switch
@
Safety switch
;
Speed selector switch
=
Control switch
%
Grip with control switch
&
Locking catch for cutting guide
(
Cutting guide
)
Scaffold hook
+
Battery
§
Carrier plate
/
Screw for carrier plate
:
Bandsaw blade cover
∙
Screw for bandsaw blade cover
$
Guide grooves
£
Bandsaw blade guide
|
Bandsaw blade
¡
Pulley
Q
Fastener for pulley
W
Rubber ring
E
Bandsaw blade guide channel
R
Battery status indicator
T
Battery release button
Z
Clamping lever for bandsaw blade
U
English 21