Publicidad
Idiomas disponibles
Idiomas disponibles
7
Step 7
Locate downrod assembly (#2). Loosen ball screw on black hanging ball
to free lock pin. Black hanging ball will slide down. Remove ground
screw and green ground wire. Remove hanging ball from downrod and
save all parts. Insert fan wires through downrod. Screw downrod into
top of fan motor housing, being careful that wires are pulled through.
Lock Pin
Downrod
Assembly
(#2)
All manuals and user guides at all-guides.com
Green Ground
Wire
Ball Screw
Hanging Ball
Downrod
Fan Motor Housing
8
Step 8
Position downrod so the hole in the downrod aligns with the hole in
the flange coupling on the motor. Insert safety bolt (S6) through coupling
and downrod and attach nut. Tighten firmly. Tighten set screw "A"
against downrod. Connect antenna wire and place decorative cover (#4)
and canopy (#3) over downrod assembly. Replace hanging ball, insert
hanging pin through downrod and tighten set screw "C" in hanging ball
into downrod.
Threaded
Set Screw Hole
Ground
Hanging
Wire
Pin
Ball
Screw
Hanging
Ball
Safety Bolt & Nut
WARNING:
Failure to completely tighten downrod as described in steps 7 & 8 above could
result in the fan loosening and possibly falling.
IMPORTANT: Black antenna wire must be connected for fan to function.
Set Screw (C)
Downrod (2)
Canopy (3)
Decor Cover (4)
Antenna Wire
Set Screw (A)
Motor Housing (5)
Publicidad
