PROUSER IBC15000B Modo De Empleo página 8

Please Read Carefully Before Using The Device
This system is intended to be used only with 12V & 24V Lead Acid Batteries, e.g. Wet, Gel, AGM
(including Calcium-) and 12.8V 4-cells LiFePO
• 12 V batteries with a capacity of 50 - 400 Ah
• 24 V batteries with a capacity of 25 - 200 Ah
• 12.8V 4-cells LiFePO4 Lithium batteries with a capacity of 30 - 200 Ah
Preparing The Battery
It is recommended to disconnect the battery from the car if possible. This will avoid possible damage to
the alternator, your car´s electronic system and damage to the bodywork from possible spillage. If you
remove the battery from the vehicle, always remove the grounded terminal from the battery at first. To
avoid sparks, make sure all accessories of the vehicle are turned off. A marine (boat) battery must be
removed and charged on shore. (To charge on-board requires special devices designed for marine use).
Follow your battery manufacturer´s precautions and preparatory measures, such as removing or not
removing cell caps while charging. Make sure the charging rate is not over your battery manufacturer´s
suggestion.
For permanently sealed batteries, it is not necessary to carry out the following checks. Don´t try
to open a sealed or maintenance-free battery.
Firstly remove the caps from each cell and check that the level of the liquid is sufficient in each cell. If it
is below the recommended level, top up with de-ionized or distilled water.
ATTENTION: Under no circumstances should tap water be used. The cell caps should
not be replaced until charging is complete. This allows any gases formed during charging
to escape. It is inevitable that some minor escape of acid will occur during charging.
Connecting The Charging Cables
Connect the clamps to the battery in the following order:
8
OPERATION
. This charger is suitable to charge...
4
1. Connect the positive charging lead
(RED) to the positive terminal post of
the battery (marked +).
2. Connect the negative charging
lead (BLACK) to the negative post of
the battery (marked -) or to the
Chassis of the car. Please do not
connect to fuel lineso or carburettor
which are not supposed to be
connected.
It is important to ensure that all
connections
contact with their respective terminal
posts.
3. Now you can connect the charger
to the mains supply and start
charging by selecting the proper
charging mode as explained below.
are making good