Publicidad
Idiomas disponibles
Idiomas disponibles
g)
Do not wear loose clothing or jewelry. Keep hair, clothing, and gloves away
from moving parts. Loose clothing, jewelry, or long hair can be caught in
moving parts.
h)
The unit is not a toy. Children should be watched to ensure that they do not
play with the unit.
2.3.
Safe use of the unit
a)
Do not overload the unit. Use tools that are suitable for the application. A
correctly selected unit will do a better and safer job for which it was designed.
b)
Do not use the unit if the ON/OFF switch does not function properly (does not
turn on and off). Units that cannot be controlled by the switch are unsafe,
cannot operate, and must be repaired.
c)
Keep unused equipment out of the reach of children and out of the reach of
anyone unfamiliar with the unit or this instruction manual. These units is
dangerous in the hands of inexperienced users.
d)
Keep the unit in good working condition. Check before each use for general
damage or damage to moving parts (cracks in parts and components or any
other condition that may affect the safe operation of the unit). If damaged,
have the unit repaired before use.
e)
Repairs and maintenance should be carried out by qualified personnel using
only original spare parts. This will ensure the safety of use.
f)
To ensure the designed operational integrity of the unit, do not remove
factory-installed covers or loosen screws.
g)
When transporting or moving the unit from storage to the place of use,
observe the health and safety rules for manual handling applicable in the
country where the unit is used.
h)
Avoid situations in which the machine stops under heavy loads during
operation. This can cause overheating of the drive elements and consequent
damage to the equipment.
i)
Do not move, shift, or rotate the machine while in operation.
j)
Do not leave the unit switched on unattended.
k)
Clean the unit regularly to prevent permanent dirt build-up.
l)
The provided value of vibration emission is measured according to the
standard measurement methods. The value of vibration emission may change
if the unit is used under different environmental conditions.
m) Do not obstruct the air inlet or outlet.
n)
Do not start up an empty unit.
o)
Do not tamper with the unit to alter its performance or design.
p)
Keep the unit away from sources of fire and heat.
q)
Do not overload the unit.
r)
Do not block the ventilation openings of the unit!
Publicidad
