Publicidad
Idiomas disponibles
Idiomas disponibles
Key safe (item number 2121, 2141)
Open the key safe's door
ƒ
Remove the covering cap by loosening the four cross-headed
ƒ
screws on the back of the door
Remove the four spacers the covering cap was screwed onto using
ƒ
a 7 mm open-ended spanner and then turn the lock's knob to the
closed position
Then lift the central plate upwards to remove it
ƒ
Remove the 13 mm nut at the bottom end of the plate (at the
ƒ
height of the knob) and, at this point, lift the metal plate below off
the lock spindle, so you can reach the nut securing the spindle with
a 19 mm open-ended spanner. Remove this carefully. At the same
time, remove the cross-headed screw at the top end of the plate
through the opening in the cross. You can now remove the lock
and reach the battery compartment.
Key safe (item number 2126, 2146)
Open the key safe's door
ƒ
Remove the protective cap from the battery compartment to reach
ƒ
and replace the batteries
Then replace the protective cap
ƒ
After changing the battery, reinstall everything following the above
instructions in reverse. Ensure that the rubber seal around the lock is
in the correct position.
Restoring the lock to factory settings (resetting)
(Master card lost, but safe must be open)
Remove one of the two batteries. (Read the 'Replacing the battery'
ƒ
section to find out how to reach the battery compartment)
Press and hold the # key and re-insert the removed battery; the
ƒ
blue LED flashes twice
three times within 3 seconds. The blue LED flashes twice
lock is now reset to factory settings. All the stored information has
been deleted.
, release the # key again. Press the # key
5
5
DE
EN
. The
Publicidad
