Publicidad
Idiomas disponibles
Idiomas disponibles
SYMBOLS
To reduce the risk of injury, user must
read instruction manua
Wear ear protection
Wear eye protection
Wear dust mask
Warning
Li-ion battery. separate collection,
and battery must be recycled
Do not burn
Do not expose to rain or water
For indoor use only
Double insulation
T 2.5A
Fuse
Positive terminal
Negative terminal
EN
OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
1. BEFORE PUTTING INTO
OPERATION
A) CHARGING THE BATTERY
The battery charger supplied is
matched to the Li-ion battery
installed in the machine. Do not use
another battery charger.
The Li-ion battery is protected
against deep discharging. When
the battery is empty, the machine
is switched off by means of a
protective circuit: The tool holder no
longer rotates.
In a warm environment or after heavy
use, the battery pack may become
too hot to permit charging. Allow
time for the battery to cool down
before recharging.
When the battery is charged for
the first time and after prolonged
storage, the battery will only accept
approximately 60% charge. However,
after several charge and discharge
cycles the battery will accept a 100%
charge.
B) HOW TO CHARGE YOUR BATTERY
PACK (SEE FIG A1)
NOTE:
a) Do not use any charger other than
that specifically provided for use
with the equipment.
b) If the battery pack is very hot
you must remove your battery pack
from the charger and allow time
for the battery to cool down before
recharging.
c) The battery in your new tool is not
charged when it leaves the plant.
Therefore it must be full charged
before using the first time.
d) Please charge the battery to reach
31
Publicidad
