Publicidad
Idiomas disponibles
Idiomas disponibles
24 Lever
25 Switch
Technical data
Cordless Jigsaw .....PSSPA 20-Li B2
Nominal input voltage U .............. 20 V
Idle speed n
..................800 - 3800 rpm
0
Saw stroke .................................. 26 mm
Cutting depth
in wood ......................... max. 135 mm
in non-ferrous metal .......... max. 20 mm
in steel (soft) ..................... max. 10 mm
Weight (without battery).... Approx. 1.5 kg
Sound pressure level
(L
) ................... 75,1 dB(A), K
pA
Sound power level
(L
) .................86,1 dB(A), K
WA
Vibration (a
) .........................................
h
Wood a
....... 3.98 m/s
h,B
Metal a
....... 4.10 m/s
h,M
Temperature.......................... max. 50 °C
Charging process ...................4 - 40 °C
Operation .......................... -20 - 50 °C
Storage .................................0 - 45 °C
Attention! An up-to-date list
of battery compatibility can
be found at:
www.lidl.de/akku
This device must be operated with
the following rechargeable batteries:
PAP 20 B1, PAP 20 B3.
This type of battery may be charged
with the following chargers: PLG 20 A3,
PLG 20 A4, PLG 20 C1, PDSLG 20 A1.
Levels of noise and vibration were deter-
mined according to the standards and reg-
ulations in the declaration of conformity.
= 5 dB
pA
= 5 dB
WA
; K= 1.5 m/s
2
2
2
; K= 1.5 m/s
2
The specified total vibration value and the
stated noise emission value have been
measured according to a standardised test
method and can be used to compare one
power tool with another.
The specified total vibration value and the
stated specified noise emission value can
also be used for a provisional assessment
of the load.
Warning: The vibration and noise
emissions may deviate from the
specified values during actual use
of the power tool, depending on
how the power tool is being used
and, in particular, what kind of ma-
terial is being worked on.
Safety measures for the protec-
tion of the operator are to be
determined that are based on an
estimate of the actual vibration load
under the real operating conditions
(for this, all parts of the operating
cycle are to be taken into account,
for example, times in which the
electric tool is turned off, and those
during which it is turned on but run-
ning without a load).
Safety instructions
Ensure that the safety instructions are ob-
served when operating the trimmer.
Symbols and icons
Symbols on the trimmer:
Carefully read these operating in-
structions.
Warning: hot surface
There is a danger of burns!
GB
IE
23
Publicidad
