Publicidad
Idiomas disponibles
Idiomas disponibles
MINIMUN
MAINTENANCE
INTERVALS
DISINFECTING
CLEANING
INSPECTING
When using maintenance products, follow the manufacturers' directions and read the manufacturer's
MSDS, Material Safety Data Sheets. You can purchase a recommended disinfectant from Ortotecsa
Customer Service (Back of Manual) or your Ortotecsa distributor.
12.2. Maintenance procedures
Motor
Motors are equipped with sealed greased ball bearings that do not require lubrication. Vent holes in the
motor and motor cover shell must be cleaned periodically to allow free air flow and prevent overheating.
Hard Water
The mineral properties of hard water, if allowed to build up over a period of time, have the potential for
creating damage to the moving parts of the turbine assembly. We recommend the installation of a water
softener or if that is not possible, the use a water softening agent.
12.3. Troubleshooting
When there is a significant loss in pressure at the turbine assembly
Check water inlet holes underneath the pump, clean away any foreign material.
Add water, pump body must be completely submerged.
Motor does not start when switch is turned on
Check your power source.
Have a qualified technician check switch.
Motor ceases operation
Check for motor overloads: Possible causes are:
a.
Blocked motor ventilation holes
b.
Excessive current load
c.
Read Working Instructions
The motor is equipped with an overload protector. In an overheated condition, the motor will
automatically shut off until it has returned to a normal operating temperature.
To treat that condition properly:
Personnel has to have the necessary training
It has taken the necessary time to cool the unit
The unit has to be disconnected from Mains
Operation and maintenance manual Rev2
EACH
AS
EACH
USE
NEEDED
WEEK
X
X
X
X
EACH
MONTH
X
30
Publicidad
