Trust AYCT-102 Manual De Instrucciones página 4

EN
AYCT-102 REMOTE CONTROL
1. Channel switch
Slide the channel switch to I, II, III or IV to access 16
different channels (4 x
1 2 3 4
2. Control 1 Trust Smart Home receiver per
channel
To control receivers individually, assign a seperate channel
( and ) to each receiver. Read the receivers
1 2 3 4
manual for the code learning procedure.
3. Control multiple Trust Smart Home receivers
per channel
To control several receivers simultaniously, assign the
same channel (for example
the receivers manual for the code learning procedure.
4. Group function
Assign the button to multiple receivers to switch a
G
group of receivers ON/OFF simultaniously (no dimming).
Read the receivers manual for the code learning
procedure. The button can always be used, regardless
G
of the channel switch setting (I, II, III or IV).
5. Manual operation of a Trust Smart Home on/
off receiver
A Press ON to switch the receiver on.
B Press OFF to switch the receiver off.
4
).
) to those receivers. Read
1
6. Manual operation and dimming with a Trust
Smart Home transmitter
Press ON once to switch the receiver on.
A
B Press ON again to activate the dim-mode. The light will
slowly dim up and down.
C Press ON a third time to set the desired light intensity.
D Press OFF to switch the receiver off.
The receiver will return to the last light level when
switched on again.
7. Manual operation of a Trust Smart Home
receiver for electric screens
A Send an ON-signal to raise the screen.
B Send an ON-signal again to stop.
C Send an OFF-signal to lower the screen.
D Send an OFF-signal again to stop.
Read the receivers manual to reverse the direction of the
screen, if needed.
8. Replace transmitter battery
A Open the battery compartment by screwing it open.
B Place a new 3V CR2032 lithium battery. The polarity
should match the symbols on the holder.
C Close the battery compartment.