GAGGLE Parade 4 Manual De Instrucciones página 10

SECURING CHILDREN - HARNESS OPERATION
Avoid Serious injury To children From Falling or Sliding out:
• ALWAYS use harness provided to safely hold child into seat.
• Snugly adjust harness around each child.
• NEVER leave children unattended, even when sleeping.
• Always keep children in view.
• DO NOT allow children to climb onto buggy or stand in seat.
1. Shoulder harness should be adjusted
prior to child being placed in seat. The
lowest position (1) is for a small child.
The middle position (2) is for a medium
size child. The top position (3) is for a
large size child up to 50 lbs. The
shoulder belts should be as even with
the shoulders as possible. See Figure 1.
To reposition to a different height, pull
out the harness strap anchor from the
back of the seat. Rotate the Anchor 90
degrees and push through the seat
from the back to front. Select the
correct opening and reverse the
procedure. Pull on the strap to make
sure the anchor is seated securely.
Refer to Step 9 of the assembly.
1. Secure child with harness straps by
positioning harness strap (5) between
legs and placing shoulder harness
straps (3) over shoulders and waist
strap (2) around child's waist. Snap
buckle tabs together into top of har-
ness buckle (4).
2. To tighten the entire harness, adjust
the strap (2) around the waist using
the slip buckles (1).
See Figure 2 and 3.
WARNING
STEP 1
AB20105_G14
Note: Make sure both seat back
anchors are placed into a slot at
the same hieght.
STEP 2
2
AB20105_G15
10
3
2
1
Figure 1
1
Figure 2
3
4
5