Descargar Imprimir esta página

Levenhuk Wezzer BASE L80 Guia Del Usuario página 5

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 21
Levenhuk Wezzer BASE L80 Thermohygrometer
EN
The kit includes: base station, sensor, USB cable, user manual, and warranty.
Also required (not included):
2 AAA batteries for each sensor
2 AAA batteries for the base station
Caution! Please remember that mains voltage in most European countries is
220—240V. If you want to use your device in a country with a different mains
voltage standard, remember that use of a converter is absolutely necessary.
Getting started
Base station
Connect the power cable to the device and the DC adapter (not included) via a
USB plug and connect to the AC power supply; or
Open the battery compartment cover (12) and insert 2 batteries according to
the correct polarity. Close the cover.
NOTE! It is recommended to use an adapter for the continuous
operation of the base station, although battery power is also possible.
Wait until the indoor temperature is displayed on the base station.
Sensor
Open the battery compartment cover (4) and insert 2 batteries according to the
correct polarity. Close the cover.
Sensor connection
Place the base station and the remote sensor within the effective transmission
range. If the values are not received from a channel, сheck the batteries and
try again. Check if there is any source of interference. When changing batteries,
replace the batteries first in the base unit, and then in the sensor, to re-establish
the connection. If an adapter supplies power to any of the devices, briefly
disconnect the power to that device when replacing the batteries. If you change
the batteries only in one of the devices (for example, in the sensor), the signal may
not be received correctly. The effective range may differ depending on the unit's
position. Due to interference (various remote control devices, etc.), the maximum
distance between the base unit and the sensor may be significantly reduced. In
such cases, we suggest moving the base unit and sensor a little.
NOTE! Although the sensor is weather resistant, never place it in direct
sunlight or in the rain or snow.
5

Publicidad

loading