Publicidad
Idiomas disponibles
Idiomas disponibles
●
Set the machine to the correct speed.
●
Always hold the machine tightly by the handle and second handle (2).
●
When drilling wood and metal, set the percussion-drilling switch (3) to drilling.
●
When drilling masonry, set the percussion-drilling switch (3) to percussion drilling.
●
When using the machine as a screwdriver, set the percussion-drilling switch (3) to drilling.
●
Set the direction switch (4) to the correct direction.
●
Never change the direction of motion when the machine is switched on.
Care of the Tools
Overload
Never use excessive force when drilling. Too much pressure reduces the speed of the machine, and
the required power is greatly reduced. This may result in overlo ad, which can damage the motor of
the drilling machine. When the drilling machine becomes too hot, allow it to run for two minutes
without a load and then interrupt working for a short time. Clean the drilling machine with a clean
cloth and a brush. Ensure that the ventilati on slits are not blocked.
Warning: Always use the additional grips which come with the appliance. Losing control of the
appliance may result in injuries.
Technical Data
Voltage:
Frequency:
Power input:
No load speed:
Chuck size:
Drilling capacity:
Steel:
Concrete:
Wood:
230V~
50Hz
850W
0-3000/min
13mm
13mm
13mm
25mm
- 04 -
120V~
60Hz
7.5A
0-3000/min
Publicidad
