Trust ATMT-502 Manual De Instrucciones página 9

ATMT-502 TIMER REMOTE CONTROL
EN
1. LCD screen layout
1. Timer program
2. Clock
3. Unit selection
4. Low-battery indicator
5. Repeat daily
2. Remove pull strip
1. Open the battery compartment by screwing it open.
2. Remove the battery pull strip
3. Close the battery compartment.
3. Control 1 Trust Smart Home receiver per unit
To control receivers individually, assign each receiver to a
seperate unit (1 to 16). Read the receiver's manual for the
code learning procedure.
4. Control multiple Trust Smart Home
receiver per unit
To control several receivers simultaniously, assign several
receivers to 1 unit (1 to 16). Read the receiver's manual for
the code learning procedure.
5. Manual operation of a Trust Smart Home
on/off receiver
1. Press [6] and [5] to select a UNIT.
2. Press ON to switch the receiver on.
3. Press OFF to switch the receiver off.
6. Manual operation of a Trust Smart Home
dimmer receiver
1. Press [6] and [5] to select a UNIT.
2. Press ON once to switch the receiver on.
3. Press ON again to activate the dim-mode.
The light will slowly dim up and down.
4. Press ON a third time to set the desired
1
6. Once setting
7. Random setting
8. On-time
9. Off-time
10. Transmit LED indicator
light intensity.
5. Press OFF to switch the receiver off.
7. Manual operation of a Trust Smart Home
electric screens receiver
1. Press [6] and [5] to select a UNIT.
2. Send an ON-signal to raise the screen.
3. Send an ON-signal again to stop.
4. Send an OFF-signal to lower the screen.
5. Send an OFF-signal again to stop.
Read the receiver's manual to reverse the direction of the
screen, if needed.
8. Set clock time
1. Press [CLOCK] for 3 seconds until the time
indicator begins to flash.
2. Press [6] and [5] to change the hour.
Press [ENTER].
3. Press [6] and [5] to change the minute.
4. Press [ENTER] to confirm the clock time setting.
9. Program a timer setting
Press [TIMER] for 3 seconds until the program screen
appears.
10. Select memory address (1-12)
1. Press [6] or [5] to select a memory address.
2. Press [ENTER] to confirm.
11. Select a UNIT (1-16)
1. Press [6] or [5] to select a UNIT.
2. Press [ENTER] to confirm.
12. Program ON-time
1. Press [6] or [5] to change the hour.
2. Press [ENTER].