Tecno-gaz ORION TECH Manual De Uso Y Mantenimiento página 58

See drawing 199
Operation and
maintenance manual
At the end of adjustment, manually reposition the cover (1) in its original
position.
In the double yoke version for spring adjustment please refer to section
8.4.1, while for the swinging adjustment please refer to section 8.4.2 of
ONDAL's "Operating Instructions" manual.
7.2 Clutch adjustment
The brakes are set during installation. Like all the other mechanical
parts, the brakes are also subject to wear.
If the Product does not remain in a stable position, the braking force will
have to be adjusted by means of the brake screws.
Use a flathead screwdriver to increase brake force,
turning the screws (1) and (2) of the arm brake clockwise.
To increase the braking force at the head, turn the two brake screws (3
and 4) clockwise using a flathead screwdriver.
In the double yoke version,
"Operating Instructions" manual.
7.3 Periodical checks to be performed on the
Product
Making any changes to this device is forbidden.
Perform the Product electrical check
At the time of start up and after each maintenance job, perform electrical
tests and jobs indicated in the IEC 62353 standard.
MU_029_EN 07/11/18
Rev.0 Page 20 of 35
please refer to section 8.4.3 of ONDAL's
EN