Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance
Racks
To keep the racks clean, remove them from the cavity, and soak them in lukewarm
soapy water. Then, scour soil off of the racks using a plastic scouring pad. If the
racks do not slide in and out smoothly after you have cleaned them, rub the side
rail guides with wax paper or a cloth containing a few drops of cooking oil. This
will help the racks glide more easily on their tracks.
NOTE
• Do not put the racks in a dishwasher.
• If a rack does not slide in and out smoothly, apply a few drops of cooking oil to
the oven rack guides.
• If a rack becomes too difficult to slide in or out, lubricate the rack with graphite
lubricant.
• To purchase the graphite lubricant, contact us at 1-800-SAMSUNG (726-7864).
• For online shopping, visit http://www.samsungparts.com/Default.aspx and search
for part DG81-01629A.
CAUTION
• Do not leave the racks in the oven during the self-cleaning cycle. The extreme
heat generated in this cycle can permanently peel off the rack coating and make
it difficult to slide the racks on the guide rails.
• Do not spray cooking oil or lubricant directly onto the racks.
Air fry tray
To keep the Air fry tray clean, remove them from the cavity, and soak them in
Lukewarm soapy water. Then, scour soil off of the Air fry tray using a plastic
scouring pad.
NOTE
• The air fry tray is dishwasher-safe.
CAUTION
• Do not leave the air fry tray in the oven during the self-cleaning cycle. The
extreme heat generated in this cycle can permanently peel off the air fry coating,
their color will turn slightly blue and finish will be dull.
44 English
NX60T8755SS_AP_DG68-01322A-01_MES+EN.indb 44
NX60T8755SS_AP_DG68-01322A-01_MES+EN.indb 44
Gliding Rack
• Gliding racks may be cleaned by hand with an abrasive cleaner or steel wool.
During cleaning, be careful not to allow water or cleaner to enter the slides of the
rack.
To lubricate the slides
1. Remove the rack from the oven. See
removing the gliding rack in the USING
THE GLIDING RACK section.
2. Fully extend the rack on a table or
countertop. Newspaper may be placed
underneath the rack for easy cleanup.
3. If there is debris in the slide tracks,
wipe it away using a paper towel. (Any
graphite lubricant wiped away must be
replaced - See steps 4 through 7.)
4. Shake the graphite lubricant before
opening it. Starting with the left (front
and back) slide mechanism of the rack,
place four (4) small drops of lubricant
on the two (2) bottom tracks of the slide
close to the bearing carriers.
2021-02-19 오후 6:10:49
2021-02-19 오후 6:10:49
Publicidad
