EAS ELECTRIC ECRP86EKD Manual De Instrucciones página 65

Press (Function) button to switch to the function that can be set in the current mode (see
Figure 6.10).
• Press (Function) button to go to the function setting, and the display on the wired
controller will show in turns: "
can press ▲ and ▼ buttons to switch to the selected function. (see Figure 6.11)
• Press
(Function) button to go to the function settings. Press
time to select the function, and the icon for the selected function will blink. Press
(Confirm) button to confirm the function, or
4-5-1 IDU LED Display
The "IDU LED Display" function is used to control the on/off state of display in the indoor unit.
Press (Function) button to go to the function setting page. Press
again to select "
button to confirm, and "
LED Display" function will turn off. (see Figure 6.12)
", "
→
Blink
", and the IDU LED Display icon "
" will light up, or press
", " ", " ", "
→ → →
Figure 6.11
(Cancel) button to cancel the function.
Start
Off
Figure 6.12
" will blink. Then press
(Cancel) button to cancel, and the "IDU
18
" (reserved). Alternatively, you
Auxiliary
Heater
(Function) button each
Steady on
Off
(Function) button
(Confirm)
V.2