Publicidad
Idiomas disponibles
Idiomas disponibles
Table 5.1
Parameter
Parameter
Code
Content
Address
C0
Setting
Cooling
Only/Cooling
C1
and Heating
Setting
C2
Reserved
Set time to
remind users
C3
to clean the
filter
Settings for
infrared
C4
receiver of
wired
controller
Fan speed
setting in
1
C5
wired
controller
C6
Reserved
Display
indoor
C7
C7
room
temperature
Default
Select
Parameters
Value
F0: Main wired
controller
F0
F1: Secondary
wired controller
00: Cooling and
Heating
00
01: Cooling
Only
/
/
00/01/02/03/04 02
00: Disable
01
01: Enable
00: 3 fan
speeds
01: 4 fan
02
speeds
02: 7 fan
speeds
/
/
00: No
00
01: Yes
Remarks
If two wired controllers control one indoor unit,
the address must be different
Heating mode is not available in cooling only
setting.
/
00: No reminder to clean filter
01: 1250h
02: 2500h
03: 5000h
04: 10000h
When "Disable" is selected, the wired controller
cannot receive remote control signal,
Default is 7 fan speeds.
The bi-directional communication automatically
identifies 3 fan speeds or 7 fan speeds.
/
If "00" is selected, the wired controller will
display the setting temperature when the
backlight is off. If "01" is selected, the wired
controller will display the room temperature
when the backlight is off.
27
V.2
Publicidad
