VENTE-UNIQUE ETNA Manual Del Usuario página 11

Risk of electric shock! DO NOT OPEN! No user-serviceable parts inside!

ALWAYS disconnect this unit from the power supply before performing any assembly or cleaning,
or before relocating the electric fireplace.

ALWAYS store this heater in a dry location. NEVER use the fireplace if it has become wet.

NEVER use this heater in bathrooms, laundry rooms, or any other location where the heater
could fall into a bathtub or pool, become damp or come in contact with water.

NEVER operate this heater if the power cord or plug has become damaged, or if the grounding
pin is damaged or missing.

Place the heater near a wall outlet so an extension cord is not needed. If an extension cord is
needed, the gauge of the cord must be at least 16AWG, and the rating must be at least 2000
Watts. NEVER use a smaller gauge cord with a lower rating. Doing so may result in fire or electric
shock.

ALWAYS plug this unit directly into a wall outlet. NEVER plug into a surge protector or multi-outlet
tap/adapter.

NEVER overload the circuit. If this heater trips the circuit breaker, unplug all other appliances on
the same circuit before the
as this heater.

NEVER plug this heater into an outlet that is old, cracked, or has any loose wires or connections.
Plugging this heater into a faulty outlet could result in electric arcing within the outlet and cause the
outlet to overheat or catch fire.

ALWAYS check your heater cord and plug connections with each use!
i) MAKE SURE the plug fits tight in the outlet! Faulty wall outlet connections or loose plugs can cause
the outlet to overheat.
ii)Heaters draw more current than small appliances. Overheating may occur even if it has not oc
curred with the use of other appliances.
iii)During use check frequently to see if the plug outlet or face plate is HOT!
iv)If the outlet or face plate is HOT, discontinue use immediately and have a qualified electrician
inspect and/or replace the faulty outlets.
PREPARATION

Remove all parts and hardware from the carton and place them on a clean, soft, and dry surface.
Make sure all parts are dry, and the power cord and plug are not damaged. See
IMPORTANT SAFETY INFORMATION on pages 2 and 3.
OPERATION
NOTICE
WARNING
next use.
When the heat function is used for the first time, a slight odor may be present.
This is normal and should not occur again unless the heater is not used for an
extended period of time.
9
Avoid plugging other appliances into the same circuit