VENTE-UNIQUE ETNA Manual Del Usuario página 12

BUTTON
1. Press to turn on flame effect and
enable heater.
Heater switches will not work unless this
ON/OFF
switch is turned on.
2. Press again to shut off the power to all
functions.
1. With power turned on, press to turn on
LOW
low heat (950W).
HEAT
Low heat must be on to use high heat.
2. Press again to turn off low heat.
1. With power and low heat turned on, press
to turn on high heat (1950W). Low heat must
HIGH
HEAT
be on to use high heat.
2. Press again to turn off high heat.
Note: Feet located on bottom are adjustable.
Adjust to the height that you want before using.
Temperature Limiting Control
This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe
temperature, the heater will automatically turn OFF. To reset:
1. Unplug the power cord from the outlet.
2. Turn the ON/OFF switch on the CONTROL PANEL to OFF.
3. Wait 5 minutes.
4. Inspect the fireplace to make sure no vents are blocked, or clogged with dust or lint. If they are, use a
vacuum to clean the vent areas.
5. With the POWER switch in the OFF position, plug the power cord back into the outlet.
6. If the problem continues, have your outlet and wiring inspected by a professional.
ACTION / FUNCTION INDICATION / RESULT
1. Flame effect and power light on switch
turn on.
The heater is now enabled.
2. Power lights, heaters, and
flame effect turn off.
1. Heater and fan turn on low
(950W).
2. Low heat and fan turn off.
Flame stays on.
1. Heater and fan turn on high
(1950W).
2. High heat and fan turn off. Low heat
and flame stay on.
10
Switch
Location